Product Catalog
Serving the Southeast since 1969
Zebra AP 6511 Access Point
Overcome the challenges of dormitory and hotel room connectivitiy
The AP 6511 is expressly designed for one of the most challenging wireless LAN environments- dormitory and hotel guest rooms. Standard service personnel can install the AP 6511 in minutes, not hours, using existing category 5 or 6 cabling already in the walls. The installation is predictable and repeatable –two key reasons the AP 6511 will dramatically lower the installation time and cost of a room wireless LAN. The AP’s sleek “hide in sight” design and minute size match the decor of any room.
-
ENHANCED MOBILITY AND SECURITY
Support fast, secure roaming and rate scaling. Pre-emptive roaming and load balancing are supported when connected to an RF Switch to increase reliability and network resilience. This unique multi-purpose device can execute and enforce the IDS/IPS security policies configured in the wireless switch, and can also be utilized as a 24×7 dedicated sensor with wireless IPS from AirDefense solutions.
-
FULL 802.11N PERFORMANCE WITH STANDARD AND DUAL BAND SUPPORT
Simplify and reduce the total cost of installation using standard Power-over-Ethernet (PoE). Operate in either 2.4Ghz or 5.0Ghz frequency bands to support 802.11b/g/n or 802.11a/n wireless LANs.
-
MODULAR INDUSTRIAL DESIGN FOR FLEXIBILITY
The mounting bracket features six unique hole patterns to match most telecom plates worldwide. A keystone, snap-in port provides a fast method to connect any secondary cabling behind the wall to the AP. If the snap-in port is not used for a secondary cable, it can be dedicated as a switched Fast Ethernet port. To further add modularity and flexibility in network design, a three-port Fast Ethernet Module can be field installed via a snap-in access port.
Network Interface
Network Standards
802.11a, 802.11b, 802.11g, 802.11n
Performance Characteristics
Data Rates
802.11b/g: 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, and 54Mbps 802.11a: 6, 9, 12, 18, 24, 36, 48, and 54Mbps 802.11n: MCS 0-15 up to 300Mbps
Physical Characteristics
Available mount configurations
Mount over any structured wiring telecom box, or on a flat surface.
Dimensions
5″ x 2.95” x 1” (12.8cm x 7.5cm x 2.54cm). 12oz (0.34Kg)
Dimensions (HxWxD)
5″ x 2.95” x 1” (12.8cm x 7.5cm x 2.54cm). 12oz (0.34Kg)
LEDs
Two single color status LEDs; power, error, packets, operating frequency
Physical interfaces
10/100Mb auto-sensing via 8-pin header
10/100Mb auto-sensing
Weight
1 lbs / 0.5 kg
Power Characteristics
Integrated power over ethernet support
Standards-based IEEE 802.3af
Operating Current
0.170w (typical)
Operating voltage
802.3af supply: 48 VDC @ 12.95W (typical), 36 VDC to 57 VDC (range)
Radio Specifications and Networking
Data rates supported
802.11b/g: 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, and 54Mbps 802.11a: 6, 9, 12, 18, 24, 36, 48, and 54Mbps 802.11n: MCS 0-15 up to 300Mbps
Layer 2 and Layer 3
802.11-802.3 bridging, 802.1q VLAN tagging and trunking, Dyn DNS, DHCP server/client
Management
Independent management via SSH, Telnet. Adopted management by Controller AP available at first release. Adoption by RF switch available in future software release.
Maximum transmit power settings
20dBm
Network standards
802.11a, 802.11b, 802.11g, 802.11n
Operating bands – EU
FCC EU 2.412 to 2.462 GHz 2.412 to 2.472 GHz 5.150 to 5.250 (UNII -1) 5.150 to 5.250 GHz 5.725 to 5.825 (UNII -3) 5.150 to 5.350 GHz 5.725 to 5.850 (ISM) 5.470 to 5.725 GHz (Country Specific) Japan 2.412 to 2.484GHz 4.900 to 5.000 GHz 5.150 to 5.250 GHz
Operating channels
5GHz: All channels from 4920 MHz to 5825 MHz 2.4GHz: Chan 1-13 (2412-2472 MHz), Actual operating frequencies depend on national regulatory limits
QoS
802.11e, 802.1p, DiffServ, TOS
Security
Stateful Firewall, NAT, 802.1x, 802.11i, WPA2-CCMP (AES), WPA2-TKIP, WPA-TKIP, Rogue Detection, Secure guest access (HotSpot)
Wireless medium
Direct Sequence Spread Spectrum (DSSS) and Orthogonal Frequency Division Multiplexing (OFDM), and Spatial Multiplexing (MIMO)
Regulatory Specifications
Electrical safety
EN 60950-1
EMC
FCC Part 15 Class B
Environmental
EU RoHS Directive 2002/95/EEC
Human exposure EMF
EN 50385, FCC Part 2, OET Bulletin 65, RSS-102 Issue 2
User Environment
Electrostatic discharge
+/- 15 kV (Air), +/- 8 kV (contact)
Operating altitude
8, 000 ft./2438 m
Operating humidity
5 to 95% RH (non condensing)
Operating temperature
-4°F to 122° F/0°C to 50° C
Storage altitude
15, 000 ft./4572 m
Storage temperature
-40°F to 158° F/-40°C to 70° C
Wireless Data Communications
Operating Channels
5GHz: All channels from 4920 MHz to 5825 MHz 2.4GHz: Chan 1-13 (2412-2472 MHz), Actual operating frequencies depend on national regulatory limits
White Papers
- Previous Page
